2007-03-16 // 12:29:07
Esther.Z.Schnickenacke
Thanks for all that! It sounds really interesting. There must be lots of things you could try out on this basis.

2007-03-16 // 10:21:53
Esther.Z.Schnickenacke
How do you do this exactly? You open a bit at the side (in the dark?) and then what exactly do you do before you stick it back together?

^ Actually, this one hasn't been flashed. The operation has to be started during the early beginning of the development, but the process has to start a little... so usually I start manipulating 10 approximative seconds after pulling the pic out of the camera. For this one, I opened the corners, one by one, slowly, opening each one in 2 or 3 steps sticking and un-stickin several times for getting these shapes as strong as possible. And then sticked everything back together for 20/30 more seconds. We're still exeperimenting all that can be done... You can even stick back both parts upside down and this will start to print on the positive but upside down, so you'll have both partial images on the print. (see »link ) The greys that you print after sticking back will be different if you have flashed when it was opened or not. Hope this was clear enough...